U101-F Heavy Duty Flowmeter

U101-F Heavy Duty Flowmeter

This Flowmeter is to measure the exact volume of the dispensed fuel. which is designed for non-commercial use only. this flowmeter is reliable ,inexpensive, simple installation and easy calibration on the workplace.

Materials:

Body: teflon

seals: Buna-N

Technical Specifications:

Litre: 4 digits

Totalt: 8 digits

Flow rate range:20L~120L/min

Accuracy:±1%

Environmental condition:-40~~+70degree

Package:

Product ID Net Weight Cross Weight Dimension

U101-F 8kg/case of 1 9kg/case of 1 28×25×18cm/case of 1

e hydraulic pulse so as to increase inner discharge of measurement transducer, affecting fuel dispenser’s accuracy. The incorrect pipeline installation makes the whole hydraulic system much unstable --- pressure pulse increases. As higher oil temperature or vacuum pressure, oil viscidity will reduce, affecting measurement transducer in two facets. One is to increase inner leak, the other is to decline the stability of hydraulic system. From above analysis, it is known that high vacuum pressure of pump inlet is not always good for fuel dispenser’s normal operation. One pipe connect to fuel dispenser several fuel dispensers Some filling stations, in order to reduce installation cost, adopt one pipe to connect several fuel dispensers, which is very unscientific. In this type of installation there would be brought two facets of troubles: one is that, as some fuel dispensers stop operations, some still work, air would be suck from stopped dispensers so as to affect the accuracy of working fuel dispensers. The other trouble is that if several fu fuel dispenser el dispensers work at same time, there would be mutually interfering, increasing flow pulse and inner leakage so as to affect accuracy. 1.2 Pipeline installation in positive pressure Delivery oil through positive pressure refers to in delivery process the inlet of fuel dispenser is positive pressure, which is adopted in the following situations. One is that delivery oil from high position tank, the other situation is tat adopt submersible pump in tank to delivery oil to fuel dispenser. The latter situation is more often. The Article 6.2.6 in GB50156-2002 the Design and Construction of Vehicle Filling station stipulated that if several fuel dispensers adopt same one pipe, each is affected and lead to uneven influx. Therefore, in order to ensure accuracy, the pipeline between fuel dispenser and tank should scientifically design and installation, using as few as elbow, keeping inner wall smooth of pipe. These are beneficial to reduce pressure and electricity loss, and to decl fuel dispenser

An ART of 0000 is not allowed.　　 Default ART value is 0001.　　 Examples:　　 Amount = 1234.56 ART=0001 Result = 1234.56　　 0001 is the default value and as the last four digits 3456　　 are a multiplication of 1 no rounding updown occurs.　　 Amount = 0123.45 ART=0002 Result = 0123.46　　 The last four digits 2345 must be rounded updown by　　 two. As there are 2 numbers the same distance apart which　　 are a multiple of 2 2344 and 2346 the original value is　　 fuel dispenser rounded up.　　 Amount = 1234.56 ART=0005 Result = 1234.55　　 As the nearest (multiple of 5) value to the original 3456　　 is 3455 in this case the original value is rounded down.　　 Amount = 1234.56. ART=0010 Result = 1234.60　　 As the nearest (multiple of 10) value to the original 3456　　 is 3460 in this case the original value is rounded up.　　 fuel dispenser Please note that dispensers that do not permit this Data_Id　　 to be changed remotely should:　　 Reject any write attempts with a Data_ACK value of　　 2 (Read OnlyNot Writable).　　 Must set the Data_Id to the hard-coded value.　　 When a master resetcold start occurs on the dispenser　　 device the dispenser should reset this Data_Id to its　　 default value.　　 PCD Handling:　　 Where the proprietary pump connected to the PCD can　　 not support this rounding mechanism directly the PCD　　 will have to treat this Data_Id as having a hardcoded and　　 unchangeable value. (See above for more explanation).　　March 2006 IFSF - STANDARD FORECOURT PROTOCOL FP31_2.23　　 fuel dispenser

nd energy, the news for the patriots has been bad. Intervention is not dead, of course; but, as the past few weeks have shown, international capital markets are restricting its scope. The mishaps started in January when France s politicians, including Mr de Villepin, manned the barricades against Mittal Steel s hostile bid for Arcelor, a big employer in France. On June 25th, after one of the most acrimonious battles in European takeover history, Arcelor heeded its shareholders wishes and succumbed to Mittal s advances (see article). In February Mr de Villepin brokered a merger o fuel dispenser f Gaz de France, the state-controlled gas utility, and Suez, a private water-and-power company, to prevent a hostile bid for Suez from Italy s ENEL. Italian bankers and politicians came out so strongly in support of ENEL that it is now in a stronger position to bid for Suez. Last week Mr de Villepin discovered that not even his own ranks fully support the energy project any more and postponed it until autumn. This means that it may not happen a fuel dispenser t all. Most recently Mr de Villepin has struggled to contain the crisis over the delay of up to seven months in deliveries of Airbus s huge A380 passenger jet. He dispatched Thierry Breton, his finance minister, to talk to other big shareholders. Mr Breton has repeatedly promised to broker a neat fix, but so far a solution has eluded him. Defenders of state intervention argue that without it France would not have world-beaters in business, such as the two leading luxury-goods groups (LVMH and PPR), one of the biggest insurers (AXA), as well as leaders in cosmetics (L Oréal) and food (Danone). Mittal won because of a fragmented shareholder base interested only in making a quick buck, fumes Jean-Pierre Chevènement, a former socialist government minister. He blames Europe s single market for the triumph of globalised capital, the dictatorship of cash and the contempt it shows for France s interests. Moreover, attempts to keep the markets and foreigners at bay are by n fuel dispenser